Optimum Efficiency
DSA's attention to ergonomics ensures easy, accurate and reliable dosage setting: once the dosage has been set, it is fixed by tightening the locking ring. The dispensers then function with no need for subsequent checking or adjustment.

Versatile
DSA flexibility, is a range of dispensers which adapt perfectly to all environments. The options of external injection and special materials or kits for viscous products make DSA Proportional Dispensers as good as universal.

Medicating Systems

• Simple Installation

• Dose into any water line header tank or trough

• Low cost operation

Installation is simple. A flow sensor supplied by Cambridge Agricultural is fitted into the water line to be dosed. The Select doser is wall mounted and is connected to both the signal line from the sensor, and a 12V DC power supply either from a plug-in mains transformer or a battery. Dosed product is pumped into the drinking water system either into a header tank, or the water pipe line via a valved connector.

The colour coded pump tubes have been tested for stability against most commonly used dosing products. If in doubt, contact Cambridge Agricultural.

The Select doser will start to pump as soon as a flow of water is detected. There is a screen prompt offering to prime all delivery lines before proportional pumping commences.

Medicating Systems

Simple & Easy!

Place the stock container on the drive box.

Put the follower magnet into the stock container where it will centre over the drive magnet in the drive box.

Turn on the power (240V AC) and the follower will rotate.

Add the required amount of water and powder product. Some products may need to be physically mixed initially. Afterwards, the Spinstir will keep powder particles in suspension during dosing.

Wash out stock container after use.